I just picked up two Murray Track 2's. One is in good condition the other had an engine fire and is going to need a bit of work. Since it's in this condition I'm planing to hot rod it just a little. I've got a Briggs Animal engine with a few goodies that I'm going to put on it so it may just be a sporty little ride.
The problem I'm having is that the neck headset bearings need to be replaced and they are an odd size. The only 1.5" bearings that I've found are threadless which will not work. I've looked at everything form motorcycle bearings to BMX and mountain bike bearings and nothing has matched up yet. Does any one know where I can get these bearings?
The only thing I can think of so far is to sleeve the neck and use some bike bearings that are easy to find. If anyone has any ideas please throw them out here and lets kick them around to see what would work best. Thanks guys.
Corey
The problem I'm having is that the neck headset bearings need to be replaced and they are an odd size. The only 1.5" bearings that I've found are threadless which will not work. I've looked at everything form motorcycle bearings to BMX and mountain bike bearings and nothing has matched up yet. Does any one know where I can get these bearings?
The only thing I can think of so far is to sleeve the neck and use some bike bearings that are easy to find. If anyone has any ideas please throw them out here and lets kick them around to see what would work best. Thanks guys.
Corey