pulse

Hey, I finally got my modified predator 212 running and onto my Carter Brothers Go Kart. Once I was finally able to take it for a spin (which was fun as s%*t) I noticed oil seeping out of the pulse pump which is mounted on top of my top plate. My pulse is coming from the hole where the...

Where on valve cover did you drill?

35$ shipped image post

can someone tell me how this all works? i see lines coming out the valve covers and crankcase on some motors and they seem to go to a fuel pump and intake manifold. anyone have a diagram of this?

OldMiniBikes has 3 to choose from. this is going on the GX390. lift is no more than 3 inches. tank outlet is lower than it should and moving the tank is not an option. i could build another tank but want to ride. not sure if these will pump enough for a 390 or not. any thoughts on these? Kawasaki...

What's the purpose of a pulse fitting on the intake manifolds? I know that you would run a line between the crank case breath to that fitting, but what does this do?

Can someone explain to me when this is needed and how i would install it? i have a the Predator engine and just did these mods: KN style filter Velocity stack adapter Manifold spacer (with Pulse fitting) #90 main jet 140 Emulsion tube Header and briggs muffler Racing plug Do i...

hi guys, i was wondering if it would be ok to put the pulse fitting in the center of the carb adaptor.i have a 22mm mikuni with a carb adaptor,and i want to drill and tap it on the top of the adaptor and center it in the adaptor,will this be ok?

I know they make pulse fittings that thread into (one of) the oil fill holes for Briggs and the yellow clone. Does anyone make one like that for the blue clone?

need to drill hole for the brass pulse nipple,on the 5 hole clone valve cover.. it looks like the best spot is right in the middle of the "o" in the lettering,(there is nothing behind that area to interfear... anyone agree?disagree?

Has anyone hooked up the walbro pulse pump? I just recieved one from AKG and there aren,t any instructions as to where the lines hook up. It has the three line conections but which is the vacume, fuel inlet and fuel outlet. Any help would be much appreciated.

Well here is the 3rd and final piece from the project that never was. Its a manifold spacer with pulse fitting. It is for a GX160, GX200 or Clone..... Description: Manifold Spacer, with Pulse Fitting. Aluminum spacer with pulse fitting can be used either in front or behind carb. Run your fuel...

Say, where are you all pulsing your fuel pumps from? I've seen them on the valve cover but is there anything wrong with using the governor rod hole? Any preferences?