I wanna use the asuzalite 5" rims. Im wondering what regular sprocket that will adapt to these type rims not a drum. Basically im going to shim from the rim to a sprocket with some type of adaptor so i can use a caliper. Any help will be great. Thanks
I see an older post where a there was some talk about using a guide to drill a hole in crankshafts to be tapped.
Are there any available out there for a 1" shaft? I could sure use one for a older B&S 6hp that isn't drilled or tapped.
O.K. Here is what I am thinking. I have a Super Bronc that I am going to put on a 9hp Clone engine with electric start.I need to find someone that can fabricate an adaptor so I can use the Heald backing plate. Basically I need a flat piece of steel approximately 3/16" thick that has the 4 holes...
i recently put a filter and a volocity stack on my 6.5 horse briggs intek motor and it dont wanna run good at all... raw gas comes out of the carb and seems like it chokes out....but i put my stock stuff back on and it runs good??? whats the prob
got them for sale... uni filter and adaptor for clone. 25 shipped. i was gna use a honda clone originally but i ended up using a tecumseh.. these items are new.
Using a 26mm Fleabay roundslide Fake Kehin on my clone that has a 1.5" OD flange and an angled filter from OldMiniBikes Warehouse that's 2 1/2" ID. Any insight from anyone on the adaptor that I need? I think my 22mm has a smaller OD on it. Thanks in advance! :thumbsup::biggrin:
Hey, I am looking for a Air filter and a adaptor. I know sometimes people have extras that they be trying to sell. So if you have one please post back or Pm me.
Thanks
I recently purchased an air filter adaptor for my clone from BMI Karts...... and after installing it and doing some troubleshooting I discovered that there is a little vent type hole ( in the carb) where the adaptor bolts up(upper left hand side of the carb) that is not drilled out on the...
I have an idea for a new part...
I'd like some feedback on whether or not you've seen this type of part already available somewhere, and if you honestly think it would be a useful part for yourself or someone else, regardless of whether or not you'd personally buy one...basically, should this...
just bought the sprocket adapter for my baja racer from OldMiniBikes. just wondering if this sprocket will bolt up? and if this is a decent sprocket. and ma bee any other sites or company's that you would recommend purchasing from...
Thinking about getting one but not sure. Get it. It will make the mount stronger. Check out my videos and pictures, it hasn't let me down yet. :scooter:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.