COUNT THE TEETH BEFORE YOU BUY FOLKS :doah:
13" Tire
3800 rpm
36 Axle
12 Clutch
49 mph, 77 mph if I crank it to 6000 :out:
Punching the numbers into the calculator and it looks awesome on paper, but I assume that I'm going to burn through clutches/have a horrible take off. Stock 212...
So i picked up my bike shortly after I got it home and the spring shaft fell out of the fork, I put it back in but its not staying so I think im missing a piece. Can someone give me some info please?
Back when I was restoring a lot of bikes I sourced these hard to find "staked" nuts and OEM engine plate bolts to give the restorations that crowning touch. No lockwasher necessary with these, just a flat washer so you get that clean factory built look.
If you...
Tecumseh shroud mounting plate, air cleaner assembly & front tin from an original white paint small block Tecumseh. Could use some fresh paint but the parts are very clean, no rust or pitting. Nice mounting plate, has the mini bike throttle holes in it.
$25 for the parts...$14 to...
Can someone help a noob understand what the benefits are of the ARC top plate? It would seem to clean up the engine if you're using a remote fuel tank... but does it provide any benefits other than appearance?
Having a little issue putting on my new throttle cable on a little manco streaker. I haven't been doin much wrenching lately. Any videos anywhere?? I need help from the throttle to the motor.
see pics,i bought these at Windber,turned out the rims too wide,and the jackshaft is too narrow for my build purposes.
im in need of a rear wheel/tire/brake/axle bolt,in other words,i need a complete rear assembly off a baja warrior bike.
will trade or sell outright,prefer to trade.
heald...
Hello.. I have a ct 70 I'm building.. I bought a rear disc brake kit off of eBay. The seller was drct70 anyway. It didn't come with any instructions or pictures for me to look at or use. Does anyone have a picture of one of these kits on a bike? Maybe a how to? Any help would be great. Thanks guys
Has a little surface rust but other than that it's in good condition. 40 shipped priority. Postal money order or paypal. I have the stock steel rear 8 inch wheel if anyone needs it as well. Will trade for briggs intek 206/animal parts
I am just completing a mini bike build , and realized my old briggs flat head recoil,rope, assembly is a different bolt pattern then the briggs Raptor 1. The raptor is a new old stock motor and did not come with recoil starter. I installed a new recoil clutch but just assumed that it had the...
Hard to find Tecumseh "Mini-Bike" specific throttle. These were reproduced by OldMiniBikes memeber Joe51 a couple years ago. This is the small block version which I believe fits all H25, H30, H35, HS40 and HS50 engines.
The attention to detail on these is superb. These were manufactured exactly the...
Looking for a Bonanza (1") hand brake lever assembly with "BTE" marked in it to match my throttle. I think it's the last piece I need for my survivor bike.
Don't have to be real pretty.
KK
Hi, hoping to find a taillight assembly for 69 Rupp Roadster, These round taillights came on Rupp's 64 to 69 I believe. The one I want has the license plate light. Thanks for any help you can give me.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.