when i get my motors done i need to dyno them and do some testing. is there anyone in mich/ohio that will rent dyno time for this? of course, they run it, but, ill make the changes and pay the time or however they do it.
mark
Davenport dyno ready to go. Comes with all wiring, sensors and computer. Comes with a few test headers also.This thing is veryyy repeatable!
4000.00 OBO 559-270-5208 located in ca. will help with shipping/delivery
FS is a very nice drop-in cam for a 5 horse + new Dyno springs.
Only a few hours on this cam and new set of correct springs from Dyno.
this is a good upgrade for your "5" with no clearance work required.
Comes in original box with cam card and new springs.
$50.00 shipped to your front door.
I have never used it, and some people say it doesn't show you much because it only ranges from 5 to 10 hp graphs.
For a good price, I would buy it.
ProRacing Sim Briggs Desktop Dyno Software : eBay Motors (item 380212386949 end time Mar-11-10 14:27:04 PST)
anyone have any info on a Dyno 95-4 cam?? I looked on Dyno's website but that cam must have been discontinued and there wasn't any info... I would like to know what the lift is and what rpm the cam starts pulling, what compression is recommended... Would this be any good for a rider??
im planning out how im going to rebuild my next engine and i have decided on the 107-SS cam, i want agressive but i dont wana weld the block. i was just wondering if anyone has used this cam and your take on it.:scooter:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.