kill

  1. melloyello

    Kill switch question

    i was removing the stock kill switch and i accidently pulled the wire out of the black enclosure...it wasn't crimped very well...... i need to hook up my handlebar kill switch to my new motor and i know one side goes to ground and the other one(black with white stripe) goes to what...
  2. J

    need help with kill switch

    I have a coil off of a 5hp briggs and can I atatch a kill switch to it, any help would be nice.
  3. J

    need help with kill switch

    I have a 5hp briggs with no kill switch. It had at one time the little lever on top of the head to touch the spark plug but that is missing. the coil just has the spark plug wire no wire to atacth a kill switch. Any thing that I could do?
  4. B

    Kill switch wont work

    I got my buddy's small Toro snowblower running but i cant get the kill switch to work. I got another switch that wasnt a direct replacement so i spliced it into the existing lines. That didnt work either. So i took the ground wire and touched it directly to the wire that runs behind the shroud...
  5. stenmark2

    I would kill for a mini like this

    Old Mini Bikes Photo Gallery - Message - Powered by PhotoPost
  6. george3

    Mini Bike Kill Switch Info

    I need kill switches for 3 mini bikes what kind is good. some look cheep. What kind do you use. what is good?
  7. B

    Wiring kill switch

    I am done with my clone install and I am wondering what wires to hookup to the kill switch on the handlebar. Is it the two wires coming from the switch on the engine, just splice them up? One ground and the other one.
  8. G

    Going in for the kill

    I like using momentary kill switches since I have forgotten to flip the switch "on" in the past. Also I DO NOT like wires showing so this is how I like to do it and the switch is right where your hand dangles naturally when sitting on the bike. The switch and/or recoil cover can be removed...
Top