seal

Tried to transfer the valve seals from my BSP head over to my UT2 head and the exhaust valve stem seal dose not fit. It is not machined for it either. Do I not run one on the UT2 head?

Anyone have some advice on removal of the Crankcase Cover oil seal on an HS50. I dont want to do any damage to the crank shaft. Trying to get the case cover off to do a rebuild.

I may have started this thread in the wrong section before. So I have a 6.50 Chipper Shredder Vac by Troy-Bilt that I did a repair of the bottom oil seal. Also replaced the Magneto due to no spark after I reassembled the entire machine it was still leaking oil from somewhere under the...

Hello Guys, I have one of these Benelli Volcano 180's and the kickstart shaft seal is leaking. Does anyone know if I need to split the cases to replace this seal or can it be accessed through the opposite side cover? Any help is greatly appreciated. Thank you, Mailman ps. Does it have a...

How do I change the oil seal on the side of the block where the crank sticks through? the bearing is good so id rather not mess with it, but the seal is bad. got a new one ready to go. the block is all tore down.

I bought this as a project for me and my 13yr old son. HELP!! It needs everything and I don't know where to start. I need to know what it is to find an engine. I don't know if it is best to buy a new engine or try to rebuild an old one. the tires are badly sun damaged. the wheels are rusted and...

Looking for the crank seal OEM part # for a ball bearing sidecover on a HS50 motor. Ole