shock

The spring I bought for the rear suspension is way too soft at 200lbs, and I wonder if 350 pounds would be strong enough!? :confused: My fear is that if I got a 700lb spring, it would be too stiff/strong. Any suggestions would be appreciated! Complete bike with me on it will probably be...

Hi all, I was talking to Mr.Kimball yesterday about the super broncs and parts for them. I asked him if he knew of any shock boot out there that would work for these and he said " a matter of fact I had another gentlemen a few weeks ago looking for these as well, he called me back about a week...

Here's a bunch of Sebac shock parts I collected over the years. These shocks were used on many of the early bikes, Cat, Bird, JC Penny, Powerdyne, etc... There is enough here to build two complete shocks +. I already did the hard part getting them apart without hurting the tubes. Rods and...

NOS H35 shortblock........Winning bid and shipping $46.

Looking for a Bonanza rear shock. Doesn't have to look be perfect, but does have to work. I have one, just need another. Below is the one I have, looking for it's mate. 11" from center to center. Thanks.

Anybody know where I can get a set of these? I am doing a Full Restoration on it and would like to keep the original shocks. Thanks, Jim

I'm in need of two rear springs for the Bonanza shocks I'm refurbishing. It seems the springs fell apart at the chrome shop and now I have tubes without springs..... Also in need of the inner top piece where the springs attach.

Looking for 2 unmolested plastic sleeves used on the rear rupp shocks for my restoration. thanks

These parts are from a 70' Roadster. $25 shipped to your door.

Shock bushing replacement steel spacer tube, 1/2" OD, 3/8" ID, 3/4" long.

1/2" Rubber Cone Washer. Similar to the original rubber bushings used on Sebac Shocks.

Shock Bushing Assembly with steel spacer tube, 1/2" OD, 3/8" ID, 3/4" long.

Old stock Sebac bushing assembly vs. modern replacement with 1/2" cone washers from a plumbing supply store and 1/2" OD steel spacer tubing.

Where can I get the shock mounting bushing. I re-painted my shocks and put them in the oven on warm to cure the paint. Well warm was too hot and you know the rest of the story.

I would like both Motovox MBX10 & A DoodleBug DirtRacer front end compatible gas or springer front end, the neck length is 5'' . I do not know the width /diameter of it though due to the lack of maintenance experience. Bad enough I found the front axle rusting and wont let me remove the...

decent set of springs off of sebac shocks, could be rechromed or polished but look fine as is, 20 dollars shipped

Looking for 1 external & 1 internal spring for a Bonanza shock like this one. (Photo courtesy of Markus - thanks!)

Sebac Shock Springs