trans

Does anyone have a original 2 speed trans for a TT500 they would be willing to part with?

Up for sale I have a NOS 30 Tooth 1st gear for a 2 speed trans setup.Don't know the original application for this,but this could be used for a Lil Indian or other setups.This has the one direction bearing in it and a Hardened internal sleeve that fits a 5/8 shaft.No hardened shaft is needed as...

I like a challenge. Putting a Pontiac OHC six in a 65 Chevy van- it's never been done before. Motor mounts are in a different location than the Chevy, engine is taller so I have to modify the crossmember mounting, and I am adding a TH2004R overdrive trans. After all that, I want to put EFI...

I found this yesterday and I don't know what it is. Any ideas? It has a serial number on the frame of G00208 Check out 2 speed trans and shifter.

Hey guys, I just started working on a project I haven't touched in two years, and I thought a few of you might appreciate it, so here it is: I bent up some 1.5" pipe and welded everything together to make the main frame, then I used some 1" to attach the spindles. I still have quite a bit of...

Tried to buy one (still will), but no success. So trying to be creative here... I'm a tool & die maker of 30+ years. I can make most anything, I just need to know what to make. I need one to duplicate. So.... Rent me yours. Send me a pic to verify you have one. Like a pic with one...

its not really a "mini" bike, but it does use a westbend engine so i thought id try to see if anyone has any parts, i need a plunger trans

need a burman trans for a mustang trail machine

can anyone post a pic of where the trans fluid goes in and where to check it at? and where to drain it? its a sax 47cc. also which chain size goes on the bike? i tried #40 but is too wide? #41 the right size? also two wires comming out of the bottom of the engine, one red, one black. the red...

So I got this thing, cover said Select O Speed, had knob with a pointer and 1-5 selection... No idea what it came from, briefly searched internets and came up with lots of ford tractor stuff. This thing weighs in at about 30lbs... Would this thing work on a minibike do you think? Probably...

Anyone know if a small belt drive, rear mounted, hand clutched transmission (like on a harley) is available for miinibikes? Pete

You'd expect nothing less than :out:crazy-/-stupid:out: from me so here goes.(should be good for a laugh atleast) I had this idea where basically you take a honda horizontal engine/clone engine you know the ones used in the pit bikes and such and have a new crankshaft made that allows you to...

Can anybody tell me how to check, add and or change the trans fluid? Just got my Benelli Dynomo out of storage after many. many years. It is a 4 speed manual. Any help would be great. Tom

Heathkit Boonie Bike