had some free time today so i figured i would port and polish the head have never done this before but figured what the hell :thumbsup: the intake side was a d shape and seemed like it should be opened up also did some grinding on the exhaust side too but not as much . there were some bad casting ridges on the face near the valves too so i sanded those out and cleaned the old valves as best as i could and honed the seats a little much better :thumbsup: any input on what else should be done is welcome
so after finding another bike in mass and stripping it down i decided it is the best frame i have for this build degreased the frame today and started sanding it :thumbsup: then organized the parts i have for this so i can figure out what i still have to order
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.