Anyone have a Speedometer/Tachometer solution for minibikes that they've implemented? Ive got some motors that have the governors removed and though it would be a good idea to atlease install a Tachometer to know when im reaching the RPM threshold (besides the usual way of finding out :rolleyes:)
Hello! I have found many digital tachometers to fit my minibike, one wire going to ground, the other to the ignition wire, but I would like to figure out how to add an analog one so it looks a bit nicer. Anyone have any insight? Im a bit of a noob but its going on a baja doodlebug with a...
I am looking for a vintage VDO 60 MPH speedometer with a 1.85 diameter body and 2.050" bezel ring that fits Rupp Roadster2 headlight bucket like the one pictured.
Thanks
Tony
Has anyone ever had to have a minibike speedometer repaired/recalibrated? Our 1974 VT-8 OEM speedometer works, however, it is way off on MPH. At about 30-35 mph it reads 55 mph.
Michael
I want to put these on my Rupp. My question is, does the speedometer activator go on the left side of the front wheel or the right? I did notice on my hub, on the right side, there is a hole where it looks like the tab would fit in to. I suppose the speedometer would only work if it was turning...
We have an inoperative speedometer on our VT-8. There is no (obvious) visible damage and everything "appears" to be connected, however, the cylindrical geared assembly that slides unto the front axle has a protruding "lever" that I suspect must somehow be secured to the wheel hub and goes around...
I am trying to get a speedo to work on my second bike project, but I am finding that the gear wants to go around with the wheel, breaking the cable. If I loosen the axle it stays in place better, but then the wheel is wobbly. Any advice on properly mounting and securing the speedometer gear...
Since I can't find a decent Roadster 2 headlight bucket/bezel I am thinking about the headlight bucket that I've seen with a speedometer opening in the top. Anyone have one of those?
Since I can't find a decent Roadster 2 headlight bucket/bezel I am thinking about the headlight bucket that I've seen with a speedometer opening in the top. Anyone have one of those?
anyone been successful pressing a new square end on a speedometer/ flexcable?
I have a cable on my rupp which is too long. I took the flanged end off and cut the cable and housing. it seems that if a lot of pressure isn't used to form it the will fray apart.....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.