trouble

New member here - I wrote up a nice little introduction to myself and my project but I keep getting denied every time I try to post it. I get a little message that says "Post denied. New posts are limited by number of URLs it may contain and checked if it doesn't contain forbidden words." I...

So I was pulling the throttle back and the throttle cable snapped can I repair it or do I have to buy a new one

Im new here so lets figure out what I have first. Bought it from a friend when I was 11. Its been almost 15 years and I still don't know who made it.

Hello, Noticed last time on the trail my front shocks would occasionally bottom out. The Mini bike is a Tomberlin Firehawk and has pretty much the same front forks as the Baja 200.. I was able to remove the shock. Undo the clip under the rubber outer seal. Remove the top Allen nut (that has...

Like it says is anyone having trouble loading pics to there photos ? I load from an I pad and have never had problems , except when there are problems with the site .

Hey any body have trouble with varicose veins and or spider veins? Not just how they look but I mean trouble--swelling, pain, hardening, redness, lesions. They are common in the arms and legs (legs tend to have more problems because they are farther from the heart). They can be caused by...

Hello, I'm taking apart my 70 Roadster for blasting and paint and I am having trouble removing the bolt that hold the swingarm to the frame. The long nut that holds the chain guard is off, but I can't remove the bolt. Is it threaded? Or could it just be bent inside from years if abuse and is...

The frame doesn't look like a blazer, but I read somewhere that they may have used a tote gote frame when they first started out. I'm still having trouble with the search options since the OldMiniBikes makeover.

try riding in one instead :laugh: GO KART-GIANT HIGH HEEL SHOE ON GO KART CHASSIS

Hello New to site and looking for help. I bought 2 Baja doodle bug bikes that come with 97cc engines. When starting off engine will hesitate and most time die. Will start easy but has trouble taking off. Both bikes have same problem. One bike might have 2 hours and the other maybe 5 hours...

I need help with carb. Can only get this thing to run with choke on. Cant find any leaks, Replaced with new head, valves and cam, new carb, and new gaskets, set tappets and still only runs good with choke on. What else can I do? Very frustrating. Thank you!!

If you are having trouble registering on the site, please e-mail with as much info as possible. An e-mail that says "Cant register" gets a "Why not?" reply. No Verification Code? If you're not receiving our e-mails, its because your e-mail provider blocked us. This happens every so often...

I replaced the throttle and throttle cable on my minibike yesterday since the last time the bike was rode the throttle stuck wide open and was ripped off of the handle bar when attempting to shut the bike off. The bike sat for about a year since then. Ever since I got the throttle hooked up the...

I changed the oil for the first time in my doodlebug 30 with the 97cc stock engine. It was running fine. I also put in a new upgraded clutch and torque convertor kit. Oil level has been triple checked and there is gas. The problem is that there is so much tension on the pull start rope and...

Hello I'm rebuilding a minibike I got when I was 10.I'm now 14 and my original motor (49cc) on it broke so I just switched it to a Honda gc160 I got with my go kart.I want to make it go at least 65mph but I don't know how many teeth my clutch should have my jack shaft in has 21 out is 21 and...

Hello all I'm back again in need of guidance. Ok so got a new dirt kart and having trouble with the power plant. Here's the specifics: standard bore clone w/ governor out, billet rod and flywheel, honda flat top piston, ported and milled head w/ 27mm int. 24mm exh. , 1/4 pushrods, billet...

So I am stumbling around the internet and I come across the oldminibikes site and as I'm browsing I start thinking WOW those are cool, so I look at craigslist for a few days and up pops this really nice lime green Doodlebug Baja Racer, guy wants $175.00 and I end up giving him $150.00, I get it...

Is anyone having issues trying to upload pictures? It stopped working yesterday but around the same time my internet has been running slower but still operational. Don't know if it is my end or OldMiniBikes. When I hit the button to upload it just sits there waiting for OldMiniBikes site and times out after a while.

first post never done this before. I have a 8hp briggs and Stratton and this sucker does not want to run its full potential or something, it is a 1inch bore with a torq a verter 41 chain I finished it today I rode it, it broke, I fixed it, it was flat I put in air, and I was ready but when...

just picked up a new mini and i got it running .. it runs and idles fine when the kick stand is down and the back tire is sitting up off the ground ... but it seems like the clutch is stuck .. the tire spins like it wants to take off but then when you let the back tire touch the ground it runs...