I have a snow blower engine, not sure of the HP I would say 8 maybe. It has a 1" dia. shaft. Is there a way to put a reducer on that to use a smaller bore clutch like 3/4" or 1/2"?
Sure can. Not terribly hard but a lot of parts involved, an existing jackshaft sure makes things easier. The clutch turns on it's bushing till it engages and off you go. I'm considering that very setup using a belt driven clutch. I have a 5hp Tec off a chipper. I knew it was a 1" shaft engine but for $25 I had to buy, runs fine.
Hmmm... ok I wonder now, doing all of that if it would cost about the same, and woudl be easier to just break down and get a 1" bore clutch and be done with it.
Hmmm... ok I wonder now, doing all of that if it would cost about the same, and woudl be easier to just break down and get a 1" bore clutch and be done with it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.