I need to replace the points and condenser on my HH70 Tecumseh due to a no-spark situation. The manual says I can set the points "by rotating the crankshaft until the point arm is resting on the high side of the ignition cam."
My problem is I can't really tell where the highest point in the...
I got an older 5hp Briggs. So I picked up a "new style coil *magnetron* with an aluminum flywheel, I will no longer be running points ignition, my question is; the keyway don't line up in the same place....is this due to the difference in the ignition set-ups, or is my motor so old they have...
I got a 76 briggs with points i want to change it over to magnatron coil do i need to remove the points an conderser set or can i leave it in there an just hook up coil an how much are points for thst motor thanks.i:shrug:
Hi, I just bought a 1970's Super Bronc. I'm wanting it to have points instead of electronic ignition, so before tearing it down I thought I'd ask here.
The engine #'s are HM80-1550-42A , and , Serilal # 41650
According to the thread here, it appears to be an 8 hp built on the 2nd day of...
Does anyone know what the part #s are for the coil,points and condensor on a 3hp tecumseh side shaft or which parts will interchange with it. I got this old motor with no shroud and I cant seem to get spark. The coil doesn't seem to have any cracks or anything and I cleaned the points up and...
What is the difference between say the H50 short block that ruppparts sells vs a standard h50? All my tecumseh engines have been points. I did nnot know they electronic ignition?
I have on old briggs 8b and im not a fan of the points and condenser setup it has, so i want to replace the old 4-post coil and points with a newer 2-post magnetron coil. I read on another thread that the coil will bolt right up, but the only thing i couldn't find was would i have to swap...
I recently made a trade transaction with another member and I would like to give him a trader point and positive feedback for the transaction but I cannot figure out how to do it. if I click on to his username I don't see anywhere to leave positive feedback for a transaction for him. if you guys...
Hey guys, I have a real low hours 5 horse flat head, It is super clean. I am going to run a billet rod with some other modifacations. My question is this...It has points. I would like to convert to CDI. Can this be a simple conversion? Thanks for your help
I'm sure this is an obvous answer, but just wondering for a 5-hp engine build if there's any particular problems with running old school points and condenser versus newer solid-state ignition? I have a '72 Briggs I'm eventually going to build up for my Toyoco Alpha 350 project, but it, of...
or by engine number? its an hm100. just kinda want to know what i have a little better. i kind of think its a cid but im not sure, any guidance would be much appreciated.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.